How to Install and Maintain Gauntlet For Handle Bar Grips

Gauntlet for handle bar grips are an essential component of any motorcycle, providing comfort, control, and a secure grip while riding. If you own a Gauntlet motorcycle and want to install and maintain handlebar grips, this blog post is for you. In this guide, we will walk you through the step-by-step process of installing handlebar grips on your Gauntlet and provide tips for maintaining them in top condition.

Step 1: Gather the Required Tools

Before you begin the installation process, make sure you have the following tools:

Screwdriver

Grip glue or adhesive

Grip safety wire (optional)

Grip wire pliers (optional)

Having these tools handy will ensure a smooth installation process.

Step 2: Remove the Old Grips

Start by removing the old handlebar grips from your Gauntlet. Depending on the type of grips you have, they may be held in place by screws or adhesive. If there are screws, use a screwdriver to remove them. If the grips are glued, gently pry them off using a flathead screwdriver or grip removal tool.

Step 3: Clean the Handlebars

Once the old grips are removed, clean the handlebars thoroughly. Use a mild detergent and water to remove any dirt, grease, or residue. Make sure the handlebars are completely dry before proceeding to the next step.

Step 4: Apply Grip Glue or Adhesive

If your new handlebar grips come with adhesive backing, simply peel off the backing and press the grips firmly onto the handlebars. If your grips do not have adhesive, apply grip glue to the inside of the grips and the handlebars. Spread the glue evenly to ensure a secure bond.

Step 5: Install the Grips

With the glue or adhesive applied, carefully slide the new grips onto the handlebars. Start at one end and work your way towards the other, applying even pressure. Make sure the grips are aligned properly and sit flush against the handlebars.

Step 6: Secure the Grips (Optional)

To provide extra security, you can use grip safety wire to secure the grips in place. Grip safety wire is a thin wire that is wrapped around the grips and handlebars, preventing them from sliding or rotating. Use grip wire pliers to twist the wire tightly and trim off any excess.

Step 7: Allow the Grips to Set

After installing the grips, allow them to set for the recommended time specified by the grip manufacturer. This will ensure that the glue or adhesive fully bonds with the handlebars, providing a strong and durable grip.

Step 8: Regular Maintenance

To maintain your handlebar grips and extend their lifespan, follow these maintenance tips:

Clean the grips regularly with mild soap and water to remove dirt and grime.

Avoid using harsh chemicals or solvents that can damage the grips.

Check the grips for any signs of wear or damage, such as cracks or tears. Replace them if necessary.

Inspect the grip safety wire periodically and tighten if needed.

By following these installation and maintenance steps, you can enjoy a comfortable and secure grip on your Gauntlet motorcycle. Remember to always prioritize safety and consult your motorcycle's manual for specific instructions. Happy riding!